3D Printing

A new way to make plastic parts.

For me anyway!

Something I’ve wanted since they came about, but could never afford or really justify. Until now!

When you come to two new projects, and re-visiting 2 old ones, that you couldn’t finish,and need to sit doen and carve parts from micartan or acrylic blocks…

You just finally buy a damn printer, and be done with it. 😉

:D

one of these
https://www.elegoo.com/products/neptune2s-fdm-printer

is now on its way!

Did a lot of research, watched a ton of videos, got the opinion of a trusted friend thats into printing, etc..


Think I made a good choice for a Non bare bones kit, entry level printer. We shall find out!

Categories: 3D Printing, Adventure Metal Works, Custom, Customized, Electronics/Media, Fabrication, MacGyver, Materials, Modifications | Leave a comment

Poor mans custom plastic parts.

Sooo… What do you do if you need fancy custom fit plastic parts but don’t have a 3D printer?

You dig out a glue gun and some dusty Lego plates!

Needed a hinged lid to close in one half of a Kobalt bit driver case. Voila;

Used a hinged bit holder insert that I didn’t need as the hinge, built up a riser and door, and a stop/latch block. Hot glued the riser/door to the hinge and the stop in the other end. Magnet and a stacked nut/washer for right height glued in for safety latch.

brown stripe because I couldn’t find another black 2×16.

Where it opens to/sits on its own.

where I can hold it open to;

This little recess here;

Fits this little latching nub on the other half off the case;

Now I have closed in socket storage;

Clears everything on the opposite side

Magnetic latch;

Latch might get a re-design.. Will see how it holds up.

More on the kit itself later. Its a companion setup for a specific power tool in a specific application. Need to finish figuring out what sockets I want in it, and collect them, along with a couple other drivers.

This kinda rough, and a bit of a redneck hack. But it works! And thats what counts to me. 🙂

Categories: 3D Printing, Adapters, Custom, Customized, Fabrication, LEGO, MacGyver, Modifications, Plastic Parts, Re-purpose, Tool Boxes, tool mods, tools-bit kit, Truck EDC | 2 Comments

Blog at WordPress.com.

%d bloggers like this: