Aaaaaaaannnnndddd, Round Two!
Wanted to build a little socket set for part of this kit to go with a 3/8″ impact driver. Needed a way to keep them all in their side of the box. Couple/three hours (not sure, 3 projects at once…) modeling and test prints for fit, 3 hours printing lid and support blocks, 1/2 hour assembly. Supports have captive magnets, and are screwed and (hot) glued in. Magnets press fit into the lid. Good and secure, can put the sockets in it and lift that side of the case! Can also put the sockets in it turn it over and shake the heck out of it, but not the sockets; lid stays put! OpenSCAD modeling, Cura slicer, Elegoo Neptune 2S printer. Hatchbox Blue and Silver PLA.
Had some bed adheashion issues, and layer adheashion issues, that resulted in the scars(once one layer is scarred it just continued upward with the scar till the top… It didn’t smooth over them. )Its clean enough for a functional print, IE not having to be purdy just solid. I don’t like it in principle, but in application I don’t mind it, it adds character.
Alaskan, Adventurer, Engineer. 