Shelf Track Bench Dogs

“Shelf what??” Your saying, right? 😉 

Bench dogs are pins, or flat jaws, that slip into dog holes– holes in the top of a work bench, for holding thing on the bench top. 

You clamp the work piece between the dog and the vice at the edge of the bench, or a bar clamp/C clamp or two. With a large grid of holes, you can hold just about anything in any position. 

I like the concept but hate the idea of having all the holes in the bench. Seems a great way to ruin a layout surface,  and a place to lose hardware. 

Then I saw this trick/tip that a fellow sent in to this month’s issue of Woodsmith magazine;

It uses cabinet shelf support rails and clip brackets as simple in line dogs for the vise; GENIUS! 

After pricing the track and clips, $3 for 6′ of track, and about $3 for 12 clips… Yeah, no brainer dude! 😉 

15 minutes with my router, and I have bench dogs!   Was a little fiddly to do, only have a 1/2″ straight cut bit, but the tracks are 5/8″ so I had to cut each channel twice for width. Track is 3/16″ thick, wanted it at least flush, I cut about 7/32″ deep to garantee it can’t catch on anything when not in use. 



Clips in place;


Then I just made the old front jaw front the vise into the cammed over jaw insert needed. Great to use that vise to make things for the vise! (Really have no idea how I survived so long without that vise!)

It works!

A few strategically placed screws makes a storage spot for the vice jaw under the end of the bench. 

And the left over ~11″ of track made a clip storage rack. 


Can’t beat simple, cheap and easy, especially if it works! 

Advertisements
Categories: Custom, custom-made-tools, Customized, Fabrication, Modifications, Repurpose, Shop Tools, Woodshop, Woodwork

Post navigation

One thought on “Shelf Track Bench Dogs

  1. Great idea! I like the clip storage too!

Create a free website or blog at WordPress.com.

%d bloggers like this: