Carving Hawk 2.0

 A couple years ago, I made this nice little tomahawk style carving hatched from an old lathing hatchet. 

I never did finish it though, it had some sharp edges from the cutting process left under the blade. I couldn’t get at them with the grinder, with the handle it was on. And didn’t want to take it off the handle.


But that handle, while nice, was a bit small and short. Another project I have going, is re-hafting a bigger hatchet I have, since it’s handle had become loose(and was epoxy set so I couldn’t tighten it).

Once I had the handle off the hatchet, I realized that what was left, with a little trimming, would be perfect for the little hawk! 

Not perfect, couldn’t go deep enough to take the whole cut out, didn’t want it any thinner.

Grinding is a little rough to look at, but is smooth to the touch. Was going more for function that visual form. 

Again, not perfect,  the shim stock I used as a wedge was a little soft, and flaked off the front edge. But it’ll work.  It’s on there like it’s set in concrete! 😀


Except two small saw cuts, about 1.5″ each, one with the band saw, one hand sawn, all shaping was done with my laminated Mora 106 carver. Then some light smoothing with sandpaper–one spot, the wedged end of the eye was on the belt sander, you can see where it scorched. Otherwise sanded by hand. I’m really enjoying work with hand tools where possible lately.

Advertisements
Categories: Axes, Custom, custom-made-tools, Customized, hatchets, Modifications, tomahawks, tool mods, Woods tools, Woodwork

Post navigation

One thought on “Carving Hawk 2.0

  1. Looks great!

Create a free website or blog at WordPress.com.

%d bloggers like this: