Kershaw Knives taken apart.

SelectFire;

This knife has a great construction, take the oyter scales off, and the knife is still together, and would function as a frame lock wonderfully. Its held together with 3 screws sepperate from the 4 screws that hold the scales on.   Made it great to fit scales to, total assembly wasn’t needed for each and every small fitment.  I could have used the scales loose for final fitting, but along the way, fitting the pockets for the screws, and the screw driver spring would have been impossible with it fully apart.

Select-Fire-Apart-1

Scale has three pocket holes in the back for the frame screws, and a large recess that clears the pin and spring that tensions the screw drivers half stop and open notches.

Select-Fire-Apart-2

Notches for the bit holders.

Select-Fire-Apart-3

Spring tail for the tension.

Select-Fire-Apart-4

The notch that holds the spring tail in place over the liner.

Select-Fire-Apart-5

OverDrive;

Ingenius opening lever on the OverDrive;

Compound leverage at its best!

 

Over-Drive-Apart-1

 

Over-Drive-Apart-2

 

Over-Drive-Apart-3

 

Over-Drive-Apart-4

Advertisements
Categories: knives

Post navigation

Comments are closed.

Blog at WordPress.com.

%d bloggers like this: